Installation & Assembly

4
EK7860182
INSTALLATION INSTRUCTIONS
LEGAL DISCLAIMER:
● This instrucon guide is done as a public service to customers of Dawn Kitchen & Bath Products, Inc. (“Dawn®”). Please consult professionals for special situaons or further assistance.
● All products should be inspected by customers upon receipt and before any installaon. Any defecve product should be reported immediately and should NOT be installed.
● Requirements may vary for installaon in a granite, marble, stone, or butcher block countertop.
● Installaon by professional installers is highly recommended. Dawn assumes no liability for any damages incurred through the use of informaon provided in this guide.
On the handspray side of the
hose, measure 15” down from
the body of the faucet and make
a mark. Install the hose weight at
the mark. Reposion the hose
weight as necessary to insure the
handspray pulls out and retracts
smoothly.
Make sure that the supply hoses
do not interfere with the pullout
hose. If necessary, reposion the
hoses.
Make a faucet hole. Make sure the
mounng surface is clean and dry.
With O-ring B (12), insert the
faucet through the faucet hole.
From below the deck, assemble
the rubber washer (13), metal
washer (14), and mounng nut
(16) to the mounng shank
(15). Tighten the mounng
screws (17).
Assemble the supply hoses to
the faucet. Be careful not
to twist the supply hoses.
Connect to the water
supply and ush to
check for leaks.
Thread
Seal Tape
A: Hot Water
B: Cold Water