Installation & Assembly

4
EB1360149
INSTALLATION INSTRUCTIONS
LEGAL DISCLAIMER:
● This instrucon guide is done as a public service to customers of Dawn Kitchen & Bath Products, Inc. (“Dawn®”). Please consult professionals for special situaons or further assistance.
● All products should be inspected by customers upon receipt and before any installaon. Any defecve product should be reported immediately and should NOT be installed.
● Requirements may vary for installaon in a granite, marble, stone, or butcher block countertop.
● Installaon by professional installers is highly recommended. Dawn assumes no liability for any damages incurred through the use of informaon provided in this guide.
Make a faucet hole. Make sure the
mounng surface is clean and dry.
Tighten the mounng shanks to the
faucet body.
Insert the faucet through
the faucet hole. From
below the deck, assemble
the horseshoe washer,
horseshoe bracket, and
mounng nuts to the
mounng shanks. Tighten
the mounng nuts with a
wrench.
Assemble the supply hoses
to the faucet. Be careful not
to twist the supply hoses.
Connect to the water
supply and ush to check
for leaks.
Thread
Seal Tape
A: Hot Water
B: Cold Water