Installation & Assembly

4
EB1359150
INSTALLATION INSTRUCTIONS
LEGAL DISCLAIMER:
● This instrucon guide is done as a public service to customers of Dawn Kitchen & Bath Products, Inc. (“Dawn®”). Please consult professionals for special situaons or further assistance.
● All products should be inspected by customers upon receipt and before any installaon. Any defecve product should be reported immediately and should NOT be installed.
● Requirements may vary for installaon in a granite, marble, stone, or butcher block countertop.
● Installaon by professional installers is highly recommended. Dawn assumes no liability for any damages incurred through the use of informaon provided in this guide.
Make a faucet hole. Make sure the
mounng surface is clean and dry.
Tighten the mounng shanks to the
faucet body.
Insert the faucet through
the faucet hole.
From below the deck,
assemble the horseshoe
washer, horseshoe
bracket, and mounng
nuts to the mounng
shanks. Tighten the
mounng nuts with a
wrench.
Assemble the supply hoses
to the faucet. Be careful not
to twist the supply hoses.
A: Hot Water
B: Cold Water
Thread
Seal Tape
Connect to the water
supply and ush to check
for leaks.