Installation Guide


Ultra Thin Glass Installation User Guide
TOP
STEP5
Installation
STEP6
Flip the glass with the protective 󽗉lm removed so that the top/bottom text are visible to the front.
1) Insert the top part of the 󽗉lm into the Align block.
2) Insert the bottom part of the 󽗉lm into the bottom part of the JIG.
②
③
①
TOP
Hold the top part of the film as shown, and bend the blue sticker as shown in [Figure 1]. Like
[Figure 2] Make sure that the protective 󽗉lm and glass are properly separated and slowly remove
the protective 󽗉lm. If it is as shown in [Figure 3], attach the protective 󽗉lm as if it is in the 󽗉rst
state and remove it carefully so that only the protective 󽗉lm can be removed.
󾖴󾖴󾖴󾖴󾖴󾖴󾖼
※Correct sticker removal direction※
※Incorrect sticker removal direction※
※In the case of the above,
there is a sound of tearing the tape※
[Figure 1]
[Figure 2]
[Figure3] Glass and protective 󽗉lm are separated together.
TOP
BOTTOM
TOP
Glass
liner film
TOP
Glass
liner film
󾖴󾖴󾖴󾖴󾖴󾖴
󾖴󾖴󾖴󾖴󾖴󾖴󾖴󾖴󾖴󾖴