Operation Manual

2 LED Status
When DV-2010 comes up, you can judge the operation status of system by LED status.
LED State Descri
p
tion
PWR
ON (Green)
When power is present,
OFF
When power is not present or fatal error
Solid Red
POST failure or device malfunction
Flashing Orange
Updating S/W image
STS
Blink per 0.1 sec Running system, not starting VoIP service yet
Blink per 1 sec Start VoIP service, not registered yet
3 sec ON, 1 sec OFF Registered to VoIP Server and can make VoIP call
ADSL
Solid Green In Sync with DSL line
OFF Modem
p
ower of
f
Blink per 0.1 sec Attempting to sync with DSL line
Solid Red DSL connection failure
INET
Solid Green DSL is u
p
and
g
et IP address
p
er PVC
OFF Modem power off or ADSL link down
Blinking Green Provision is completed and Data traffic is going through
Blinking Orange
Provision is completed but there is a PVC not allocated IP
address. Traffic is on the available PVC.
U
p
datin
g
S/W ima
g
e
Solid Red Provision is not completed
TEL
Solid Green OFF-Hook phase
OFF ON-Hook phase
LAN
ON Ethernet connection is established
Blinking Data is transmitting or receiving data
USB
ON USB is connected to a host PC
Blinking Data is being transferred over the USB connection
WLAN
ON Wireless Access Point(AP) is enabled
Blinkin
g
Data is bein
g
transferred over the WLAN connection
<Table 6> LED Status
 If there is no LED light, check the power cable connection.
 Device will be restarted when you push the Init button at the rear of DV-2010.
- Power LED will be OFF
 When you keep pushing init button about 2~3 sec, It will reload Factory default value.