Operation Manual

.
NOTE
The telephone must be switched to tone setting (not pulse) for the DV-2010 to
operate properly.
Step 4. Connect a straight-through Ethernet cable from your PC and STB to the 10/100 PC
RJ-45 LAN port and STB ports on DV-2010.
CAUTION
LAN port 1 and 2 are only dedicated for STB. So do not connect PC to these
ports. PC can only connect to LAN 3 and 4 port for the Internet.
Step 5. Insert the power adaptor cable into the power connector on the DV-2010.
WA R NI N G
Use only supplied power adaptor
Step 6. Connect the plug end of the 12V DC power adaptor cord into an electrical power
outlet.
Step 7. When the DV-2010 is properly connected and powered up, the green power (PWD)
lights and the green status (STS) LED flashes to indicate that DV-2010 is in initial
processing.
CAUTION
Do not cover or block the air vents on either the top or the bottom surface of DV-
2010 when IAD is in horizontal location. Overheating can cause permanent
damage to the IAD
.
NOTE
Power LED and INET LED are orange color blinking at the same time when IAD
is on software downloading process.
1.3 Cable connection
After the equipment is in place, see Figure 1 how to connect cable to the rear of the DV-2010.