Operation Manual

CHAPTER 2. INSTALLATION
1 Installation
Welcome to the DV-2010 which is based on Residential Gateway with integrated VoIP
terminal and ADSL modem, router, firewall, and 54g AP (Access Point) all in one compact
hardware and firmware platform. This section contains instructions that would allow you to
configure user security setting and pleasant wireless setting quickly. DV-2010 works like PnP
(Plug & Play) in order to get rid of complex setting for user convenience. Auto provisioning and
Auto Software upgrade functions are enabled on DV-2010. IAD downloads all user specific
setting as soon as it connects to the high-speed ADSL line,
1.1 Hardware Installation
1.1.1 Before Start
This section describes the hardware features and installation of the DV-2010. It is
handset-to-Internet adaptors that allow regular analog telephones to operate on IP-based
telephony networks. DV-2010 supports two FXS (Foreign Exchange Station) port and four
Ethernet interfaces for STB and PC. Two ports is dedicated for STB (Set-Top Box) and the
other ports for PC. IAD support the Internet, IPTV, VoD and VoIP at the same time using
High speed internet and specific QoS mechanism. It also has a WLAN AP (Access Point)
to offers you the freedom to roam without the burden of cables
1.1.2 Safety Recommendations
When installing and operating the DV-2010 system, follow the safety guideline provided
below to help prevent serious injury and/or damage to DV-2010 system.
(1) Do not open or disassemble this product. This system does not contain any user serviceable
parts. Maintenance is to be only performed by qualified personnel.
(2) Do not get this product wet or pour liquids into this device.
(3) Do not perform any action that creates a potential hazard to people or makes the equipment
unsafe.
(4) Use only the power supply that comes with the DV-2010.
(5) Maintain between 0୅ and 40୅ and it must be well ventilated
(6) When removing or connecting cables, always unplug DV-2010 power.