Installation manual

Mounting the Wireless Temperature Station Page 9
3. Using an adjustable wrench or 7/16" wrench, tighten the nuts.
4. Place the second U-bolt around the pole and through the two holes at the bottom of
the shelter.
Put a flat washer, a lock washer, and a hex nut on each bolt end, and tighten
the hex nuts.
Mounting on a Vertical Surface
1. With a 3/16" (5 mm) drill bit, drill two holes approximately 2" (50 mm) apart. Use a
carpenters level to ensure the holes will be level.
2. Drill two more holes 7-1/32" below the upper holes.
MOUNTING TEMPERATURE STATION ON A VERTICAL SURFACE
3. Insert the 1/4" x 1-1/2" lag screws through the at washers, and through the holes at
the top of the shelter into the post.
Using an adjustable wrench or 7/16" wrench, tighten the lag screws.
4. Insert the 1/4" x 1-1/2" lag screws through the at washers, and through the holes at
the bottom of the shelter into the post.
Using an adjustable wrench or 7/16" wrench, tighten the lag screws.
Flat
Washer
Lag
Screw
Wireless Temp Page 9 Thursday, December 7, 2000 2:09 PM