Installation manual

Page 8 Wireless Repeater
grounding your installation. For more information, contact your local lightning
protection authority and/or refer to the following articles:
✦
MIL-HDBK-419A: Grounding, Bonding, and Shielding for Electronic Equipments and
Facilities,
29 Dec 1987.
✦
National Fire Protection Association, 1997: Standard for Installation of Lightning Pro-
tection Systems,
1997 ANSI/NFPA 780, National Fire Protection Association, Quincy, MA.
✦
NEC, National Electrical Code, 1996 Edition: National Fire Protection Information,
Quincy, MA.
Mounting the AC-Power Model
Install the repeater in an attic or garage, or in one of Davis’s weatherproof shel-
ters.
1. Attach the base to the mounting surface using the #6 x 1” screws.
Use two screws (as pictured below) when attaching to a stud. Use three
screws (as pictured below) in any other case.
MOUNTING THE BASE OF THE AC-POWERED REPEATER
2. Apply power (see step 3 on page 6).
3. Reattach the repeater cover to the base.
Make sure the tabs on top of the cover snap back into their slots, locking the
cover in place.
REATTACHING THE AC-POWERED REPEATER COVER
Use two screws if attaching
to a stud.
Use three screws if attaching
anywhere else.
#6 x 1" Screws
A B