Specifications

20
Finally, choose your Logical Grouping (whether you want to test this
condition along with any other conditions).
Choose DONE if this is the only condition you want to check. Choose OR if
you want this condition or any of the other conditions you set to trigger an
alarm. Choose AND if you require this condition and all of the other
conditions you set be present to trigger an alarm. Choose XOR if you want
an alarm to trigger if only one of the conditions you are checking becomes
valid. You may use this selection for the Minus check type except that every
use of the Minus check type takes up two lines.
Press OK to save all your Alarm Output settings (except the Advanced
settings), Cancel to preserve your previous settings. Please note that the
Configuration Utility only makes changes to any settings that are different
from the previous settings. Thus, you may notice the program takes longer
times than others to set values.
Note on parameters:
• Barometer Trend parameters: Use the True check type for this
parameter. Each of the four barometer trends (rising rapidly, rising
slowly, steady, falling slowly, and falling rapidly) when used will
alarm separately. If you wish to trigger an alarm if the barometer is
falling slowly or rapidly you will need to select the first parameter on
one line and then the second parameter on the second line and link
them together using the OR grouping type.