Troubleshooting guide

5
USB Installation
USB Hardware Installation
The WeatherLink USB connection creates a direct local connection between
your computer and your Vantage Pro, Vantage Pro2 console, or Weather Envoy.
Included below are the requirements and instructions for successfully installing
a weather station and related console connection to your computer.
USB Connection Installation
Complete the local USB connection by using the instructions below:
1. Locate the console or Envoy receiving the WeatherLink USB connection.
2. Enter the console’s Setup Mode by pressing and holding DONE, then press-
ing the down arrow (-). Entering Setup Mode ensures that the station is not
writing any data and saves the current daily weather information to memory.
3. Remove the battery cover from the console back and remove all power by
removing the batteries and AC-power adapter, if present.
Note: Failure to remove power to the console before installing the data logger may cause dam-
age to the data logger or console. Plugging or unplugging the data logger while power is
applied can lock up or damage the logger.
4. Carefully insert the USB data logger into the large receptacle marked
EXPANSION inside the battery compartment.
5. Locate a free USB port on your computer and connect the USB connector to
the port.
Battery Cover
USB-mini B
USB-A
Data
Logger
USB Port
Cable
Vantage Pro or Pro2 Console