Troubleshooting guide

Next, try clearing the archive memory using the clear dialog box. You will lose

any data not already downloaded in your archive memory, but all of your cali-

bration numbers and alarm settings will remain intact. If this doesn’t work,

reboot your weather station (that is, remove, then restore all power to the sta-

tion).

Note: Make sure to put the console in Setup Mode (by pressing the DONE and DOWN arrow

keys) before removing the batteries. The ensures the station will remember the current

daily high and low values and the daily rain and ET accumulation.

V When viewing data, dashes appear in place of a value for functions other than wind

direction. Why?

If no data was recorded by a sensor (for example, the sensor was disconnected or

radio interference blocked reception) or if bad data was recorded for a sensor

(for example, the sensor was malfunctioning), the software dashes out the entry

rather than showing invalid data. You can use the record editor to correct these

entries.

V The data I want to see, such as solar radiation, soil moisture, or Temp 2 is missing com-

pletely or is greyed-out?

All optional sensors must be enabled in the Station Configuration setup dialog

box before the data will be displayed in WeatherLink. If you are not seeing data

from a sensor that is installed in your weather station, be sure check the Station

Configuration in the Setup Menu and make sure the sensor has been selected.