Specifications

82
• Carefully place the battery hatch with o-ring into position so that it seats
on top of the raised flange located around the opening of the battery com-
partment, and while holding it in place with your finger, secure it with
the three screws by turning them clockwise with a small Philips head
screwdriver. DO NOT attempt to use any other screws.
• Carefully tighten the screws until secure by alternately turning them
each one turn at a time. DO NOT overtighten.
INSPECTION
• Activate the unit and watch carefully as it performs a full diagnostic and
battery check and enters Surface Mode.
• Observe the LCD display to ensure it is consistently clear and sharp in
contrast throughout the screen.
• If any portions of the display are missing or appear dim, or if a Low Bat-
tery condition is indicated, return the unit to your Authorized AERIS
Dealer for a complete evaluation before attempting to use it.
REASSEMBLY
• Reinsert the module into the rubber boot using care when pulling it over
the tabs on top of the housing.
• Secure the Logo Bar, or Compass Assembly with the two screws by turn-
ing them clockwise using a 3/32" hex wrench. DO NOT overtighten.