Specifications

500AI

If water or corrosion is found in the battery compartment, it is best to have

your unit inspected and cleaned by an Authorized AERIS Dealer Service Tech-

nician. If you are cleaning the unit -

• Inspect the lens and case to ensure they are not cracked or damaged.

• Discard the battery and DO NOT attempt to reuse it.

• Check the o-ring seating surfaces for damage (nicks, cuts, divots, etc.).

• Flush the battery hatch and compartment with a solution of 50% white

vinegar and 50% water. Rinse with fresh water, and allow to air dry over-

night or blow dry with a hair dryer set at 'no heat'.

BATTERY INSTALLATION

• To replace the battery hatch o-ring, lightly lubricate it with silicon grease

and place it in the groove of the battery hatch (Fig. 81a). Ensure that it

is evenly seated.

NOTE: This o-ring must be a genuine AERIS part that can be

purchased from your Authorized AERIS Dealer. Use of any

other o-ring will void the warranty.

• Place a new 3.6 volt TADIRAN

, model TL-2150, .95Ah, 1.0ma, Lithium

battery, negative end first, into the battery compartment, ensuring

proper orientation of the positive (+) and negative (-) ends (Fig. 82).

Fig. 81 - O-ring Installation

Fig. 82 - Battery

Orientation/Installation

o-ring