Specifications

500AI

BATTERY REPLACEMENT

NOTE: The following procedure must be closely adhered to.

Damage due to improper battery replacement is not covered by

the limited 2 year warranty.

PRELIMINARIES

• Purge the regulator system of all pressure.

• It is not necessary to remove the HP hose from the regulator or the 500AI

from the HP hose. However, if the 500AI is fitted with a Quick Discon-

nect, disconnect it to allow removal of the boot.

• Remove the two screws that secure the Logo Bar, or Compass Assembly,

to the top of the 500AI housing (Fig. 79a) by turning them counter clock-

wise with a 3/32" hex wrench, then lift the logo bar, or compass assembly,

up and off the top of the housing.

BOOT REMOVAL

• Grasp the 500AI with both hands, palms on front sides, fingers on the

rear of the console, and thumbs to the left and right of the top center.

• Carefully push the top of the boot over the tabs on top of the module

while pressing from behind with your fingers.

• Slide the boot down (but not off) the hose, or off the Quick Disconnect.

Fig. 79 - Logo Bar Removal