Instruction Manual

3
TESTING THE SENSOR
You may test the sensor before or after you mount it.
1. Connect the sensor.
2. Make sure you are getting a leaf wetness reading on the console.
Consult the Vantage Pro2 Console manual for instructions.
3. Drop or spray water onto the sensor and make sure the reading changes.
MOUNTING THE SENSOR
Mounting the Sensor On a Wooden Surface
Use the #8 wood screws to mount the sensor on a wooden surface as shown.
Mounting the Sensor on a Pipe
To mount the sensor on a pipe, stake, or pole with outside diameter between
1" and 1-1/4" (25 mm and 31 mm), secure the sensor to the pipe using the 1-1/2"
U-bolts, 1/4" flat washers, and 1/4" hex nuts as shown below. Use a 7/16"
wrench or adjustable wrench to tighten the hex nuts.
Solar Panel