Owner manual

Table Of Contents

Setting the Transmitter ID Code Page 5

ETTING

THE

RANSMITTER

ID C

ODE

The ConsoleLink uses any of eight selectable ID codes (the default is ID Code

#1). The transmitter and receiver communicate with each other only if they are

both set to the same ID code. Use the default setting unless you have another

Davis wireless system operating nearby which you want to work separately

from the new system. The dip switch settings for the eight possible codes are

shown in the table below.

To change to another transmitter ID code:

✦

Flip dip switches 1, 2, and/or 3 on the transmitter to the desired position using the

table above.

The transmitter and receiver must use the same ID code to communicate.

If you change the ID code on the transmitter, then you must change the

ID Code on the receiver to correspond.

HANGING

THE

WITCHES

Note:

Use Dip switch #4 for testing, not for ID codes. (See ‘Testing Data Transmission” on page 6.)

When SET is on, the unit beeps each time data is transmitted.

ID C

ODE

WITCH

(default)

off off off

#2 off off ON

#3 off ON off

#4 off ON ON

#5 ON off off

#6 ON off ON

#7 ON ON off

#8 ON ON ON

UNIT ID

BEEP MODE

OFF

1234

Dip Switches