Manual

3
5. Take the same colored wire from the other cable and place it in the other hole
at the end of the splice connector you used in step 2.
Make sure you push the wire all the way in. You can check this by looking through
the clear side of the splice connector.
CONNECTING WIRES USING SPLICE CONNECTOR
6. Use pliers to snap the yellow cap into place, securing the wires.
7. Repeat this procedure for each set of colored wires.
8. Use a cable tie to secure the two cables together as shown below.
Doing this provides a measure of strain relief which should prevent the wires from
pulling apart under normal conditions. Cut off the excess cable tie when it is secure.
PROVIDING STRAIN RELIEF