Installation manual

1
Welcome!
The Vantage Pro2
™
Long Range Repeater can be used with any Vantage Pro2 wireless
transmitter station and re-transmits the information to a Vantage Pro2 compatible receiver
(Vantage Pro2 console or Envoy
®
or another Vantage Pro2 Wireless Repeater). The Long
Range Repeater works in much the same way as the Vantage Pro2 wireless repeater, but
extends the distance between a repeater and a receiver by up to 10 times that of the Van-
tage Pro2 wireless repeater (#7626 and 7627).
Long Repeater Addendum Overview
This addendum provides additions information specific to the installation and use of the
Long Range Repeaters and is intended to be used in conjunction with the Wireless
Repeater Installation Manual. The table below shows the location of the information
required to install and maintain your Long Range Repeaters:
Section/Procedure
In This
Addendum
In the Wireless
Repeater Manual
Components and Hardware X
Repeater Board Contents XX
Additional Antenna Components and Hardware X
Tools for Setup X
Additional Tools for Setup X
Wireless Repeater Introduction X
Repeater Configurations/Architecture X
Long Range Repeater Antenna Configuration X
Applying Power X
Single Repeater Installation X
Advanced Repeater Installation X
Mounting Long Range Wireless Repeater and Antennas X
Connecting External Antennas to the Repeater X
Console and WeatherLink Configuration X
Repeater Communication Troubleshooting X
Long Range Repeater Specification X