User's Manual

The component unique to the Long Range Repeater board is:

• Antenna Cables — Connects the repeater board to the external antennas.

Mounting the Wireless Repeater

The antenna configuration and wireless repeater can be mounted on a pole at designated

location. Use the brovided U-bolts for the wireless repeater and the U-bolts provided for

each antenna type to install them all to a pole. .

Installing a Repeater\Antenna(s) on a Pole

Refer to the following illustrations to install the repeater and antennas on a pole:

1. Place the repeater enclosure at a low

place on the pole to provide enough

room on the top of the pole to mount the

necessary antennas.

2. While holding the shelter against the

pole close to the bottom, place a U-bolt

around the pole and through the two

holes on at the top of the shelter.

3. Place a flat washer, a lock washer and a

hex nut on each of the bolt ends.

4. Using an adjustable wrench or 7/16"

wrench, tighten the nuts.

5. Place the second U-bolt around the pole

and through the two holes at the bottom

of the shelter.

6. Put a flat washer, a lock washer, and a

hex nut on each bolt end, and tighten the

hex nuts.

Depending on the types of antennas

selected, use the illustrations on the follow-

ing pages to assemble and mount your

selected antennas:

Flat

Washer

Lock

Washer

Hex

Nut

U-Bolt