User's Manual

Page 6 Wireless Repeater
3. Apply power to the repeater.
✦ AC-Power Model
Plug the AC-power adapter into the jack marked POWER, and into an
AC-power outlet. Watch for the LEDs to light up (as described below).
APPLYING POWER TO THE AC-POWERED REPEATER
✦ Solar-Power Model
Plug the power cord from the battery to the jack marked POWER as
shown below. Watch for the LEDs to light up, (as described below).
APPLYING POWER TO THE SOLAR-POWERED REPEATER
Both LEDs flash once when you apply power. The repeater performs a self-
diagnostic test that lasts about 7 seconds and then, both LEDs flash again
twice. After that second double-flash, the repeater begins listening for a
signal. If it finds one, the lower LED flashes as it receives a signal and then
the upper LED flashes as the data is transmitted out again.
If the repeater still cannot find a signal one minute after you apply power, it
double-flashes three times and then shuts itself down in order to save
power. If this happens, check that your transmitter is transmitting and try
repositioning your repeater for better reception. Remove and reapply power
to the repeater to make it listen for the signal.