User's Manual

23
3. Remove the installed mesh antenna by unscrewing it from the connector. You
may need to use a 5/16”(8 mm) wrench or small pliers.
4. Remove the solid grommet from the hole on the right side of the bottom of the
Gateway shelter. Run the connector end of the antenna cable up through this
hole and place the split grommet with a round hole (included with antenna)
around it and push the grommet up into the hole to seal the shelter.
5. Screw the external antenna cable into the connector. Do not over-tighten.
6. Replace the plastic cover, making sure the antenna cable exits through the
channel on the right.
7. Mount the antenna on a pole, as high as possible, using the mounting hardware
included with the antenna.
Tip: If you need longer cable on your antenna, add an Extension Cable. See page 24:
Adding an Extension Cable to your Long Range Antenna.
R
Battery
EM
Mesh
Davis
TalkCell BLE
DID: AA123456789
EM
Mesh
Batter
y
y
Ce
ll
B
LE
D
av
is
Ta
l
k
Plastic Cover
Screws
Antenna
Jack
Access
Hole
Split
Grommet
External
Antenna
Cable