User's Manual

15
4. Insert the 6-wire sensor connector into the sensor port indicated by the app.
Make sure it is aligned properly and not offset.
Note: If the Davis sensor has an RJ-plug on its
cable, use the Davis RJ Adapter, product
number 6860. Or, you can remove the plug
and strip the wires.
Try not to strip the covering back so far
that the bare wires can touch each other
when the connector is plugged in, but make sure the clamp in the sensor port is
closing on wire, not plastic. (About 1/4” [6.4 mm] of exposed wire is ideal.)
5. Run the sensor cable down and out of the box through the bottom. Make sure
it will be enclosed by the foam when the Node door is closed.
6. When all sensors are installed, close the Node door, making sure all cables are
against the foam and not the hard plastic of the door. Use included zip ties and
adhesive mounts if desired.
RJ A
d
apter,
#6860
Make sure
cables exit
against
the foam.
Adhesive
Mount
Foam
Note: Make sure none of the
sensor cables are pinched in
the door; especially the cable
on the the sensor installed in
Port 1.