User's Manual

38
Replace the junction board cover.
16. Replace the two cap plates.
(Note that the closed plate goes
on top.) Replace the solar
bracket and the threaded
spacers, with lock washers and
flat washers.
17. Align the threaded spacers
with the screws in the rain
collector base. Note that cables
should exit from the radiation
shield toward the mounting
pole or post. Screw the screws
into the threaded spacers.
18. Route the temperature/
humidity cable over the solar
bracket and back into the
transmitter shelter. Plug it back
in, then replace the foam insert snugly. Check other sensor cables to make sure
they are plugged in tightly. If you disconnected the door’s solar panel cable,
plug it back in.
19. Replace the door.
USE THESE HOLES
Threaded
Spacer
Lock Washer
Flat Washer