User's Manual

Page 14
A NOTE ON SECURING CABLES
To prevent fraying or cutting of cables, secure them so they will not whip about
in the wind. Secure a cable to a metal pole by wrapping electrical tape around
them both. Make sure cables are secure by placing clips or ties approximately
every 3 – 5' (1 – 1.6 m).
Note: Do not use metal staples or a staple gun to secure cables. Metal staples—especially when
installed with a staple gun—have a tendency to cut the cables.
If you haven’t used the entire length of anemometer cable, secure the remain-
ing coil by taping it to the pole, or hanging it on a hook on the post. Place it at
least 6" away from the antenna.
TROUBLESHOOTING
CONTACTING DAVIS INSTRUMENTS
[phone] for Technical Support, Monday – Friday, 7:00 a.m. – 5:30 p.m.
Pacific Time.
[phone] Toll-Free Order Line, Monday – Friday, 7:00 a.m. – 5:30 p.m.
Pacific Time. Our customer service representatives can answer most questions
and assist you with your purchases.
[phone] For callers outside the USA or Canada.
[phone] Fax to Customer Service or Tech Support.
www.davisnet.com Copies of User Manuals are available on the “Support”
page. Watch for FAQs and other updates. Subscribe to the e-newsletter.
[e-mail] E-mail to Technical Support.
[e-mail] E-mail to Customer Service.
[e-mail] General e-mail.
Cable Clip
Cable Tie
Anemometer Transmitter Kit Page 14 Thursday, November 30, 2000 9:53 AM