User manual

Current Weather Mode

1. Press the + and - keys to select the

baud rate.

Your Vantage Vue console supports

baud rates of 1200, 2400, 4800,

9600, 14400, and 19200.

2. Press DONE to save the baud rate

settings.

Exiting Setup Mode

You have successfully completed all the screens in the Setup Mode. To exit Setup

Mode, press and hold DONE for several seconds until the Current Weather screen

appears.

Clear All Command

After you have completed the above setup procedures and have exited the Setup Mode

and once the Vantage Vue ISS, Vantage Pro2 ISS or Anemometer Transmitter kit has

been installed, please use the Clear All command before putting your weather station

into service.

The Clear All command clears all stored high and low weather data including monthly

and yearly highs and lows, and clears the alarm settings. The command is

recommended to properly clear the console of any erroneous data when first putting

your station into use.

1. Press WIND to display wind speed on the console.

2. Press 2ND, then press and hold CLEAR for at least six seconds.

3. Release CLEAR when you see “CLEARING NOW” displayed at the bottom of the

console’s screen.

Current Weather Mode

In the Current Weather Mode you

can display the current data

readings from your station, select

units of measure, and calibrate,

set, or clear weather variables.

You can see up to eight weather

variables on the screen at the

same time, as well as the time

and date, moon phase and

forecast icons, and a graph of the

currently selected variable.

Some variables are always visible

on the console screen while most

variables share their location with one or more variables. You can select any variable

not currently on the screen to display it.

WIND

INSIDE OUTSIDE

RAIN RATE

CHILL

in/hr

F F