Owner's Manual

DISASSEMBLING AND ASSEMBLING INSTRUCTIONS

FOR CARLETON UNDERHAMMER PISTOL

WARNING : BEFORE PROCEEDING ALWAYS MAKE SURE THE FIREARM IS UNLOADED AND

POINTED IN A SAFE DIRECTION.

See exploded view at page 52 of this booklet.

DISASSEMBLING

 Disassemble the grip from the frame and barrel group by unscrewing the two side screws

(#21) and the upper one (part. # 22).

 Detach the main spring (# 6) by squeezing it where it contacts the hammer (part. # 3)

 Disassemble the plate unscrewing the screws (part. # 19 and # 20) paying attention not to

loose the sear spring (part. # 5).

 Remove the hammer (part. # 3), the sear (part. # 4) and the trigger pin (part. # 16) using a

slender alignment punch, then remove the trigger (part. # 14).

 Remove the hammer mainspring (part. # 6) by disassembling the mainspring stud (part. # 7)

and unscrewing the stud screw (part. # 25).

ASSEMBLING

4) Assemble the trigger (part. # 14) by pulling the adjusting screw (part. # 15) while it is still

inserted in the frame, paying attention that the trigger can rotate freely.

5) Put in the sear spring (part. # 5) while keeping it in position with a slender alignment punch

inserted from the left side of the gun during the time necessary to assemble all inside parts

until you insert the plate screw (part. # 20). The shorter sear spring side has to be placed in

the inside of the upper part of the frame, while the lower bent side has to lock in the trigger

front. Fit the trigger (part. # 14) inserting the trigger pin (part. # 16). First tighten the shorter

plate screws (part. # 19), then the long screw (part. # 20) paying attention to the alignment

punch, which has to be removed slowly, while you are tightening the long screw.

6) Assemble the main spring (part. # 6) in the frame back side with the main spring stud (part.

# 7) and lock it manually to its seat in the hammer.

Assemble the grip to the frame and barrel group tightening the proper

screws (part. # 21 and # 22).