Owner's Manual

LOADING AND SHOOTING INSTRUCTIONS

FOR REVOLVERS

Before proceeding, please make sure to CAREFULLY read the warning seen in the section

“IMPORTANT CAUTIONS FOR MUZZLE LOADING SHOOTING” in this booklet.

1) Keep the revolver’s barrel upward, hammer in the safety position (1st. cock) to rotate the

cylinder for loading. ( picture #48 ) Prepare the black powder charge, as suggested in the

corresponding chart, using a powder measure (item USA 192). Pour the load into one

chamber. ( picture #49 )

picture #48 picture #49

2) Always with the barrel upward, insert an over powder felt wad of the proper caliber size (item

USA 094), then seat the round ball on top of it at the chamber mouth. ( picture #50 )

picture #50

3) Rotate the cylinder to place the loaded chamber under the loading lever and push it until the

ball is well seated on the felt wad. The ball must seat slightly under the cylinder chamber rim.

Use the same procedure for all the chambers. ( picture #51 )

picture #51