Owner's Manual

1) The long bullet .451/535 grs. (items USA 526), you can make with our bullet mould block
(item USA 308-451), sized through the sizing device USA 514-450 (11,43 mm or 10,41 mm /
.450 or .449) and greased with soft grease (item USA 488). ( picture #47 )
2) Pour the proper black powder charge into the barrel using a brass long funnel (item USA
346).
3) The bullet has to be placed directly on the black powder.
4) Slightly tap the bullet, avoiding compressing powder charge too much.
5) It is necessary to clean the barrel after each round
FOR MORTIMER WHITWORTH & TRYON CREEDMOOR RIFLES
1) The long bullet .451/485 grs (item USA 521) you can make with our bullet mould block (item
USA 318-451) and the Minié bullet .450 (item USA 523) you can make with our bullet mould
block (item USA 309-450) must be sized into the proper sizing device USA 514-450 (11,43
mm or 11,41 mm / .450 or .449) and greased with soft grease (item USA 488). ( picture #47)
2) Pour the proper black powder charge into the barrel using a brass long funnel (item USA
346).
3) The bullet has to be placed directly on the black powder.
4) Slightly tap the bullet, avoiding compressing powder charge too much.
5) It is necessary to clean the barrel after each round.
FOR TRYON MATCH RIFLE
1) The Minié bullet .450 (item USA 523) you can make with our bullet mould block (item USA
309-450) must be sized into the proper sizing device USA 515-450 (11,43 mm or 11,41 mm /
.450 or .449) and greased with soft grease (item USA 488). ( picture #47 )
2) Pour the proper black powder charge into the barrel using a brass long funnel (item USA
346).
3) The bullet has to be placed directly on the black powder.
4) Slightly tap the bullet, avoiding compressing powder charge too much.
5) It is necessary to clean the barrel after each round.
FOR WAADTLÄNDER RIFLE
1) The maxi bullet .454/250 grs. (item USA 522) you can make with our bullet mould block
(item USA 308-454), must be greased with soft grease (item USA 488). ( picture #47 )
2) Pour the proper black powder charge into the barrel using a brass long funnel (item. USA
346).
3) It is recommended to put inside the barrel a carton wad 1 mm thick between the bullet and
black powder, or a felt wad sized to the gun’s caliber (item USA 097).
4) Slightly tap the bullet, avoiding compressing powder charge too much.
5) It is necessary to clean the barrel after each round.
32