Owner's Manual

LOADING AND SHOOTING INSTRUCTIONS

Before proceeding, please make sure to CAREFULLY read the warning seen in the section

“IMPORTANT CAUTIONS FOR MUZZLE LOADING SHOOTING” in this booklet.

Picture #47

FOR BRISTLEN A MORGES

RIFLE

1) The Minié bullet .447 (item USA 523) you can make with our bullet mould block (item USA

304-447) must be sized into the proper sizing device USA 515-445 (11,30 mm or 11,28 mm /

.445 or .444) and greased with soft grease (item USA 488). ( picture #47 )

2) Pour the proper black powder charge into the barrel using a brass long funnel (item USA

346).

3) The bullet has to be placed directly on the black powder.

4) Slightly tap the bullet, avoiding compressing powder charge too much.

5) It is necessary to clean the barrel after each round.

FOR GIBBS RIFLE .40 and .45 calibers

.40 CALIBER

1) The Minié bullet .400/316 grs. (item USA 523), you can make with our bullet mould block

(item USA 304-400), sized through the sizing device USA 515-400 (10,16 mm or 10,14 mm /

.400 or .399) and greased with soft grease (item USA 488).

The long bullet .400/310 grs. (items USA 526), you can make with our bullet mould block

(item USA 318-400), sized through the sizing device USA 514-400 (10,16 mm or 10,14 mm /

.400 or .399) and greased with soft grease (item USA 488). ( picture #47 )

2) Pour the proper black powder charge into the barrel using a brass long funnel (item USA

346).

3) The bullet has to be placed directly on the black powder.

4) Slightly tap the bullet, avoiding compressing powder charge too much.

5) It is necessary to clean the barrel after each round

.45 CALIBER