Owner's Manual

8g) With one hammer placed on half cock position and the other on a rest position (down),
NEVER PLACE BOTH HAMMERS AT HALF COCK POSITION AT THE SAME TIME, place the first cap;
PLACE JUST ONE CAP AT A TIME, you can place the second one only after having fired the first
barrel.
CAUTION: NEVER RELOAD A FIRED BARREL WITHOUT REMOVING CAPS FROM THE OTHER.
9g) Start now loading the left side barrel.
10g) It is possible for the recoil of the first shot to jar the second load from the powder charge so,
after having fired the first barrel, wait for at least one minute, then check the position of the
loading charge of the second barrel with the reference marks done on your ramrod. If it is
not at the right depth, press it down until the reference mark is at the muzzle of the barrel.
CAUTION : BE SURE THERE IS NO CAP ON THE NIPPLE.
LOADING MISTAKE
11g) If you have accidentally reloaded the same barrel (you will notice this after having checked
the reference marks on your ramrod), UNLOAD THE GUN COMPLETELY, using the proper
caliber bullet puller. MAKE SURE YOU HAVE REMOVED ANY CAP ON THE NIPPLE.
Using a small eye dropper or medicine dropper filled with water, forceably inject the water
into the breech plug. Water will cause the black powder to become inactive. ( picture #45 )
picture #45
After you have done this 3-5 times, wait at least 30 minutes for the black powder, to become
completely saturated with water. Further screw the bullet puller to the ramrod, insert it into
the barrel to catch the bullet; rotating the ramrod will ease the bullet pulling. ( picture #46 )
You can now remove the powder.
Picture #46
CLEANING
29