General Hints

16
LOADING MISTAKE
If you have accidentally reloaded the same barrel (you will notice this after having checked the
reference marks on your ramrod),
UNLOAD THE GUN COMPLETELY, by using a patch-puller (item
USA 555),
MAKE SURE YOU HAVE NOT ANY CAP ON THE NIPPLE.
In this case, screw the patch-puller to the ramrod, insert it into the barrel reaching the over shot
wad and pull it out. Repeat the same thing for the felt wad.
CLEANING
Our shotguns have chromed barrel bores, however the same procedures seen at point 2d and at
“C
LEANING” of section “CLEANING INSTRUCTIONS FOR SINGLE SHOT MUZZLE LOADING GUNS” in this
booklet, are to be followed.
Attention: the breech plug cannot be removed.
DOUBLE BARREL SHOTGUN WITH INTERCHANGEABLE CHOKE TUBES
Your side by side shotgun can be equipped with interchangeable chokes of various sizes. (see
table at
page 4a of this booklet)
• Never change choke tubes on a loaded firearm.
• Make sure choke tube is properly tightened before shooting. It is wise to check tube
periodically when hunting or shooting for an extended period of time.
• We do not recommend chokes tighter than improved-cylinder for steel shot.