User's Manual

Congratulations on your purchase of the
Aurora BT headset. As with all of our
products, Aurora Class headsets are
backed by extraordinary customer service
and support.
David Clark Company assumes full
responsibility for the quality and performance
of our products. We are committed to a
policy of service whereby we will respond
in a prompt and positive manner to any
question or issue regarding one of our
products.
David Clark Company products have set
the standards of performance and excellence
for customers throughout the world. Your
new Aurora Class BT headset continues
this legacy. We have earned a reputation
for excellence; we intend to keep it by
continuing to deserve your confidence.
Robert A. Vincent, President
Thank you for purchasing the Aurora BT headset
T H A N K Y O U . . .
2 WWW.DAVIDCLARK.COM
WWW.DAVIDCLARK.COM 3
In du st ri al -C LASS BT HEADSETS
C A U T I O N S & W A R N I N G S
READ AND SAVE THESE INSTRUCTIONS. Follow the instructions in this manual.
These instructions must be followed to avoid damage to this product and associated
equipment. Product operation and reliability depends on proper usage.
DO NOT USE OR INSTALL ANY DAVID CLARK COMPANY
PRODUCT THAT APPEARS DAMAGED.
Upon unpacking your David Clark product, inspect the contents for
shipping damage. If damage is apparent, immediately file a claim
with the carrier and notify your David Clark product supplier.
ELECTRICAL HAZARD.
All repairs should be performed by a representative or authorized
agent of David Clark Company. Electrical power must be discon-
nected when making any internal adjustments or repairs.
LI-POLYMER.
This product is used with Li-Polymer batteries. Do not incinerate,
disassemble, short circuit, or expose battery to high temperatures.
Battery must be disposed of properly in accordance with local
regulations.
IMPORTANT: First Use
The DC Bluetooth Headset must be
enabled by a slide switch inside the
non-mic side ear dome prior to first
use (see Figure 1 opposite). You must
remove the filter to see the slide switch.
The slide switch will need to be in the
UP position. This will be the only time it
is necessary to operate this switch.
Figure 1 - Move Slide Switch
to UP position
230-31600 Aurora User Manual 5-8.indd 2-3 5/11/15 8:00 PM