Installation manual

1
9532P-62 (03-11)
5
of 32
1. Mounting the Master Station
P
arts/Tools Required
q U
9800S Series 9800 Intercom System Master Station (40898G-01)
q Master Station Mounting Kit (40688G-63)
o 4 neoprene washers
o 4 Stainless steel screws
o 4 Nylon washers
o 4 Stainless steel washers
o 4 Stainless steel nuts
q Pencil/Pen
q Drill
q 7/32-inch Drill Bit
q Drilling Template (Figure 3)
q Philips-head screwdriver
q 11/32-inch nut driver or wrench
Procedure
L
ocation Considerations
Select a location on a flat surface that is out-of-the-way, and provides adequate room to attach all
cables. Be sure to allow for internal access, as adjustments may be necessary. The Master
Station is weather resistant, however the mounting location should be chosen to minimize direct
exposure to the elements.
Mounting
q Using the mounting template in Figure 3, mark and drill the (4) 7/32-inch holes through the
mounting surface.
q Remove the cover and position the Master Station on the mounting surface and confirm
mounting holes.
q Mount the Master Station using the hardware provided. Slide nylon washer over each screw
before using. Place a neoprene washer between the Master Station and the surface where
each screw is located. Use a stainless-steel washer on the back side of the surface under
each nut. Secure tightly with a stainless-steel lock-nut. See Figure 2.
q The installer may wish to leave the cover removed from the Master Station, as internal
adjustments may be necessary later during the installation. Be sure to replace cover and
tighten the four screws when adjustments are completed.