Specifications

84 of 104
RUBBER BOOT Bidder Complies: Yes ( ) No ( )
The front and rear of the pump and plumbing compartment shall be enclosed to contain the heat. The
rear shall have openings for the plumbing only. A rubber boot shall be supplied around the plumbing,
at the front, sides and rear of the pump compartment, the boot shall allow the plumbing to flex and
keep cold air out.
INSULATION/SEAL, PUMP & PLUMBING COMPARTMENT Bidder Complies: Yes ( ) No ( )
A foil faced polyethylene insulation blanket shall be installed on the inside of the pump and plumbing
compartment on all four sides and the top under the cargo area. The insulation shall also act as a heat
seal for all inlets, outlets, valve controls and drains.
PUMP HEATER LIGHT Bidder Complies: Yes ( ) No ( )
A red indicator light shall be provided on the pump panel. This light shall be activated when the pump
compartment heater is on.
SPECIAL COLOR VALVE CONTROL KNOB Bidder Complies: Yes ( ) No ( )
There shall be one (1) special red colored valve control knob provided. They shall all be supplied for
the tank to pump outlets.
GAUGES, VACUUM and PRESSURE Bidder Complies: Yes ( ) No ( )
The pump vacuum and pressure gauges shall be liquid filled and manufactured by Class 1, Inc.
The gauges shall be a minimum of 4.00" in diameter and shall have white faces with black lettering,
with a pressure range of 30.00"-0-600#.
Gauge construction shall include a Zytel nylon case with adhesive mounting gasket and threaded
retaining nut.
The pump pressure and vacuum gauges shall be installed adjacent to each other at the pump
operator's control panel.
Test port connections shall be provided at the pump operator's panel. One shall be connected to the
intake side of the pump, and the other to the discharge manifold of the pump. They shall have 0.25 in.
standard pipe thread connections and non-corrosive polished stainless steel or brass plugs. They shall
be marked with a label.
This gauge shall include a 10 year warranty against leakage, pointer defect, and defective bourdon
tube.
PRESSURE GAUGES Bidder Complies: Yes ( ) No ( )
The individual "line" pressure gauges for the discharges shall be interlube filled and manufactured by
Class 1.
They shall be a minimum of 2.50" in diameter and shall have white faces with black lettering.
Gauges shall have a pressure range of 0-400#.
The individual pressure gauge shall be installed as close to the outlet control as practical.
WATER LEVEL GAUGE Bidder Complies: Yes ( ) No ( )
An electric water level gauge shall be incorporated in the pressure controller that registers water level
by means of nine (9) LEDs. They shall be at 1/8 level increments with a tank empty LED. The LEDs
shall be a bright type that is readable in sunlight, and have a full 180-degree of clear viewing.
To further alert the pump operator, the gauge shall have a warning flash when the tank volume is less
than 25 percent, and shall have down chasing LEDs when the tank is almost empty.
The level measurement shall be ascertained by sensing the head pressure of the fluid in the tank or
cell.