Specifications

76 of 104
drainage and hose drying. Tray shall be held in place by a mechanical spring loaded stainless steel
latch that automatically deploys upon loading the tray to hold the trays in place during transit.
CROSSLAY/EQUIPMENT STORAGE ENCLOSURE FULL WIDTH Bidder Complies: Yes ( )
No ( )
The forward portion of the body containing the crosslays and transverse storage area shall be
enclosed. The enclosure shall be provided on both sides of the body full width of the body
compartmentation.
The enclosure shall be fabricated from bright aluminum treadplate painted to match the front of the
body. The enclosure shall be bolted on construction.
Gortite roll-up doors shall be provided on both sides for access.
ROLL-UP DOOR Bidder Complies: Yes ( ) No ( )
Each door shall be double faced, aluminum construction, with a painted finish to match the body
compartments, and manufactured by A&A Manufacturing (Gortite).
Lath sections shall be an interlocking rib design and shall be individually replaceable without complete
disassembly of door.
Between each slat at the pivoting joint shall be a PVC inner seal to prevent metal to metal contact and
prevent dirt or moisture from entering the compartments. Seals shall allow door to operate in extreme
temperatures ranging from plus 180 to minus 40 degrees Fahrenheit. Side, top and bottom seals shall
be provided to resist ingress of dirt and weather and be made of Santoprene.
All hinges, barrel clips and end pieces shall be nylon 66. All nylon components shall withstand
temperatures from plus 300 to minus 40 degrees Fahrenheit. Hardened plastic shall not be acceptable.
A non-locking polished stainless steel lift bar shall be provided. The lift bar shall be located at the
bottom of door and have latches on the outer extrusion of the doors frame. A ledge shall be supplied
over lift bar for additional area to aid in closing the door.
Door(s) shall be constructed from an aluminum box section. The exterior surface of each slat shall be
flat. The interior surfaces shall be concave to provide strength and prevent loose equipment from
jamming the door from inside.
To conserve space in the compartment(s), the spring roller assembly shall not exceed 3.00" in
diameter. A roll-up door that retracts below the compartment ceiling (garage door style) shall not
acceptable.
The header for the roll-up door assembly shall not exceed 4.00".
A heavy-duty magnetic switch shall be used for control of "open compartment door" warning lights.
All mechanical components of the door shall be warranted to be free from defects in materials and
workmanship for the lifetime of the vehicle. All parts covered under this warranty shall be to the
original owner.
The roll up doors exterior paint finish shall be warranted against blistering, peeling, bubbling, lack of
adhesion or any other manufacturing or material defect for a period of six (6) years.
The roll up doors shall also be warranted against corrosion perforation for a period of ten (10) years.
PUMP ACCESS COVER Bidder Complies: Yes ( ) No ( )
A gray, heat resistant vinyl cover with quarter turn fasteners shall be provided on the forward portion
of the pumphouse of a PUC to aid in keeping heat inside the plumbing area, rear of the crosslays on
the pump access opening.