Specifications

65 of 104
PERMANENTLY MOUNTED SHELF Bidder Complies: Yes ( ) No ( )
A permanently mounted compartment shelf shall be provided. A total of two (2) shall be installed One
in D3 even with the bottom of the ladder storage and one in forward portion of P3, 38" above the floor.
MOUNTING TRACKS Bidder Complies: Yes ( ) No ( )
There shall be recessed tracks installed vertically to support the adjustable shelf(s).
Tracks shall not protrude into any compartment in order to provide the greatest compartment space
and widest shelves possible.
The tracks shall be provided in each compartment except for the one that contains the pump operator's
panel.
ADJUSTABLE SHELVES Bidder Complies: Yes ( ) No ( )
There shall be one (1) shelf, with a minimum capacity of 500 pounds provided. The shelf construction
shall consist of aluminum with 2.00" sides. Each shelf shall be painted Spatter Gray as standard. Each
shelf shall be infinitely adjustable by means of a threaded fastener, which slides in a track.
The shelves shall be held in place by .12" thick stamped plated brackets and bolts.
The location of the one (1) shelf shall be to be determined.
RUB RAIL Bidder Complies: Yes ( ) No ( )
Bottom edge of the side compartments shall be trimmed with a bright aluminum extruded rub rail.
Trim shall be 3.12" high with 1.50" flanges turned outward for rigidity.
The rub rails shall not be an integral part of the body construction, which allows replacement in the
event of damage.
Rub rails shall be attached with bolts and spaced from the body with isolators that shall help to absorb
any moderate impact without damaging the body.
BODY FENDER CROWNS Bidder Complies: Yes ( ) No ( )
Polished stainless steel fender crowns shall be provided around the rear wheel openings.
A brushed stainless steel unpainted fender liner shall be provided to avoid paint chipping. The liners
shall be removable to aid in the maintenance of rear suspension components.
A dielectric barrier shall be provided between the fender crown fasteners (screws) and the fender sheet
metal to prevent corrosion.
The fender crowns shall be held in place with stainless steel screws that thread directly into a
composite nut and not directly into the parent body sheet metal to eliminate dissimilar metals contact
and greatly reduce the chance for corrosion.
HARD SUCTION HOSE Bidder Complies: Yes ( ) No ( )
Two (2) lengths of 6.00" clear corrugated PVC hard suction hose, 10' in length, shall be provided. The
hose shall be equipped with a long handle female coupling on one (1) end and a rocker lug male
coupling on the other end. Couplings shall be hard coated aluminum.
HOSE TROUGHS Bidder Complies: Yes ( ) No ( )
Two (2) stainless steel hard suction hose troughs shall be provided.
The troughs shall be installed in the hatch compartment located on the driver's.
The troughs shall be installed side by side with an aluminum treadplate door at the rear. The door shall
have a lift and turn latch.
A floor shall be provided above the hard suction hose inside the hatch compartment to allow storage of
addition equipment in the compartment.