Specifications

64 of 104
The compartment shall have the capacity to hold up to 215 pounds of equipment and be located on the
passenger's side under the front body. The exterior dimensions of the compartment shall be
approximately 8.00" high x 26.00" wide x 21.00" deep.
AIR BAG/CRIB STORAGE ,215# Bidder Complies: Yes ( ) No ( )
A storage area shall be installed under the front body. Construction shall be of bright aluminum
treadplate with an aluminum slide out drawer and a D handle. The outer panel of the drawer shall be
covered in brush finished stainless steel.
The compartment shall have the capacity to hold up to 215 pounds of equipment and be located on the
driver's side under the front body. The exterior dimensions of the compartment shall be approximately
8.00" high x 34.50" wide x 18.00" deep. The interior dimensions of the compartment shall be
approximately 6.00" high x 29.50" wide x 15.50" deep.
BODY MOUNTING Bidder Complies: Yes ( ) No ( )
There shall be blue Loctite® applied to all body mounting bolts
COMPARTMENT GRATING Bidder Complies: Yes ( ) No ( )
Vinyl grating shall be provided in 21 compartments. The locations are, all compartment floors, tray,
shelves and the cargo floor to the rear of the water tank fill dome.
The vinyl grating shall be .50" thick and be cross bonded by .25" diameter ribbed sections spaced for
aeration.
MOUNTING, STOKES BASKET Bidder Complies: Yes ( ) No ( )
Mounting shall be provided for a stokes basket above the crosslays. A sheet metal enclosure shall be
fabricated. A strap shall be provided to prevent the stokes from sliding against the outer doors. The
enclosure shall be removable for plumbing access.
The size of the stokes basket shall be 7" deep x 24.50" wide x 86.00"long.
PARTITION, VERTICAL COMPARTMENT Bidder Complies: Yes ( ) No ( )
Four (4) partitions shall be bolted in Install 2 in D3, lower rear portion, 6" away from the center
mounted slide-out tool board, up to the bottom of the ladder storage. Install 2 in P3, full height, locate
20" back from the front wall and ahead of the hopper tube. Each partition shall be the full vertical
height of the compartment.
PEGBOARD Bidder Complies: Yes ( ) No ( )
There shall be one aluminum pegboard provided. The pegboard shall be installed install on the back
wall of compartment D2.
The pegboard shall be .188" thick with .20" diameter holes punched 1.00" on center in a pegboard
pattern.
The board shall be spaced 1.00" from the wall to provide room for fasteners.
AIR BAG STORAGE Bidder Complies: Yes ( ) No ( )
There shall be a three (3) racks installed for storing three (3) air bags in the install three to the bottom
of each shelf and tray in P1 compartment.
The rack shall be fabricated from .125" aluminum, painted to match the compartment interior. The rack
shall have half moon cutouts for grabbing the air bag. Velcro straps shall be installed to hold the air
bags in place.
The size of the air bags shall be Sizes One (1) KPI-1 – 6” x 6” x 5/8” One (1) KPI-3 – 6” x 12” x 5/8”
One (1) KPI-5 – 10” x 10” x 5/8” One (1) KPI-12 – 15” x 15” x ¾” Two (2) KPI-17 – 15” x 21” x ¾”
Two (2) KPI-22 – 20” x 20” x ¾” One (1) KPI-32 – 24” x 24’ x ¾”.