Specifications

63 of 104
It shall be a minimum of 0.188" thick with 0.203" diameter holes in a pegboard pattern with 1.00"
centers between holes.
A 1.00" x 1.00" aluminum tube frame shall be welded to the edge of the pegboard.
The board shall be mounted on an undermount-roller bearing type slide rated at 250 lb with a factor of
safety of 2.
To ensure years of dependable service the slides shall be coated with a finish that is tested to
withstand a minimum of 1,000 hours of salt spray per ASTM B117.
To ensure years of easy operation, the slides shall require no more than a 50 pound force for push-in
or pull-out movement when fully loaded after having been subjected to a 40 hour vibration (shaker)
test under full load. The vibration drive file shall have been generated from accelerometer data
collected from a heavy truck chassis driven over rough gravel roads in an unloaded condition. Proof of
compliance shall be provided upon request.
The board shall have positive lock in the stowed and extended position.
The toolboard shall be mounted on adjustable tracks side to side within the compartment.
There shall be Three (3) provided.
The toolboard(s) shall be located to be determined.
DRAWER ASSEMBLY Bidder Complies: Yes ( ) No ( )
A slideout drawer assembly shall be installed front driver's side compartment.
The clear dimensions starting at the top of the cabinet with the first drawer shall be 8.25" high x
21.00" deep. The clear dimensions of the second drawer shall be 6.25" high x 21.00" deep. The clear
dimensions of the third drawer shall be 4.25" high x 21.00" deep. The clear dimensions of the fourth
drawer shall be 4.25" high x 21.00" deep. Each drawer shall be the same width and not exceed 48.00".
The drawers shall have a capacity of 250 pounds.
The drawers shall be mounted in a cabinet housing constructed of light gray powder coated aluminum
with anodized aluminum frames. The housing shall be 24.00" deep, and completely enclose the drawer.
A full-length aluminum extruded rail shall be provided at the top edge of each drawer. This rail shall act
as the latching mechanism as well as the handle for each drawer.
There shall be a total of one (1) provided.
TOOL BOX Bidder Complies: Yes ( ) No ( )
A tool box shall be furnished.
The outside size shall be 22.00" long x 10.00" wide x 10.00" deep.
The tool box shall be black in color.
Construction shall be of .50" polypropylene plastic with joints and seams nitrogen welded. A cut out
carrying handle shall be provided on each end.
There shall be two (2) provided. It shall be located ship loose.
AIR BAG/CRIB STORAGE ,215# Bidder Complies: Yes ( ) No ( )
A storage area shall be installed under the front body. Construction shall be of bright aluminum
treadplate with an aluminum slide out drawer and a "D" ring handle. The outer panel of the drawer
shall be covered in brush finished stainless steel.