Specifications

62 of 104
PULL-OUT ADJUSTABLE HEIGHT TRAY Bidder Complies: Yes ( ) No ( )
There shall be one (1) slide-out tray with 2.00" sides and a capacity of 500 pounds provided. Capacity
rating shall be in the extended position.
Slides shall be equipped with ball bearings for ease of operation and years of dependable service.
The tray shall be painted to match the compartment interior.
Tray location shall be In P1 low.
Automatic locks shall be provided for both the "in" and "out" positions. The trip mechanism for it shall
be located at the front of the tray for ease of use with a gloved hand.
Each tray shall be adjustable up and down within the compartment.
SLIDE-OUT/TILT-DOWN TRAY Bidder Complies: Yes ( ) No ( )
There shall be four (4) slide-out trays provided.
The capacity rating (in the extended position) shall be 215 pounds minimum.
Approximately two-thirds of the tray shall slide-out from its stored position and shall tilt 30 degrees
down from horizontal. The vertical position within the compartment shall be adjustable.
Construction shall consist of .188" thick aluminum for the tray bottom and end, and special aluminum
extrusions for the tray sides, front and tracks. The tray shall be painted to match the compartment
interior.
The tray corners shall be welded for strength and rigidity.
The tray shall be equipped with ball bearing rollers for smooth operation.
Two spring loaded locks shall be provided at the front of the tray, one on each end.
Rubber padded stops shall be provided for both the in out tray position.
The tray(s) shall be located in Two in rear portion of P3. One in P2. One in P1 centered between slide-
out tray and shelf.
SWING OUT TOOLBOARD Bidder Complies: Yes ( ) No ( )
A swing out aluminum toolboard shall be provided.
It shall be a minimum of .188" thick with .20" diameter holes in a pegboard pattern with 1.00" centers
between holes.
A 1.00" x 1.00" aluminum tube frame shall be welded to the edge of the pegboard.
The board shall be mounted on a pivoting device at the back of the compartment on the top and
bottom to allow easy movement in and out of the compartment. The maximum tool load shall be 400
pounds.
The board shall have positive lock in the stowed and extended position.
The board shall be mounted stationary within the compartment.
There shall be One (1)toolboard(s) provided, shall be painted to match compartment interior, and
installed over the wheel well compartment, driver's side, D2.
SLIDE-OUT TOOLBOARD Bidder Complies: Yes ( ) No ( )
A slide-out aluminum toolboard shall be provided. It shall have a painted finish to match the
compartment interior.