Specifications

59 of 104
To conserve space in the compartments, the spring roller assembly shall not exceed 3.00" in
diameter. A garage style roll door shall not be acceptable.
The header for the roll-up door assembly shall not exceed 4.00".
A heavy-duty magnetic switch shall be used for control of open compartment door warning lights.
COMPARTMENTATION, REAR Bidder Complies: Yes ( ) No ( )
A roll-up door compartment above the rear tailboard shall be provided.
Interior dimensions of this compartment shall be approximately 36.75" wide x 42.38" high x 25.88"
deep in the lower 33.75" of height and 15.75" deep in the remaining upper portion. Depth of the
compartment shall be calculated with the compartment door closed.
A removable access panel shall be furnished on the back wall of the compartment.
Rear compartment shall be open to the rear side compartments. The transverse opening shall be a
minimum of approximately 22.00" wide x 28.75" high.
Clear door opening of this compartment shall be 33.50" wide x 33.75" high.
Closing of the door shall not require releasing, unlocking, or unlatching any mechanism and shall easily
be accomplished with one hand.
ROLL-UP DOOR, REAR COMPARTMENT Bidder Complies: Yes ( ) No ( )
The rear compartment shall have a roll-up door. The door shall be double faced aluminum
construction, an anodized satin finish and manufactured by A&A Manufacturing (Gortite).
Lath sections shall be an interlocking rib design and shall be individually replaceable without complete
disassembly of door.
Between each slat at the pivoting joint shall be a PVC inner seal to prevent metal to metal contact and
prevent dirt or moisture from entering the compartments. Seals shall allow door to operate in extreme
temperatures ranging from plus 180 to minus 40 degrees Fahrenheit. Side, top and bottom seals shall
be provided to resist ingress of dirt and weather and be made of Santoprene.
All hinges, barrel clips and end pieces shall be nylon 66. All nylon components shall withstand
temperatures from plus 300 to minus 40 degrees Fahrenheit. Hardened plastic shall not be acceptable.
A polished stainless steel lift bar to be provided for each roll-up door. Lift bar shall be located at the
bottom of door and have latches on the outer extrusion of the doors frame. A ledge shall be supplied
over lift bar for additional area to aid in closing the door.
Door shall be constructed from an aluminum box section. The exterior surface of each slat shall be
flat. The interior surface shall be concave to provide strength and prevent loose equipment from
jamming the door from inside.
To conserve space in the compartments, the spring roller assembly shall not exceed 3.00" in
diameter. A garage style roll door shall not be acceptable.
The header for the roll-up door assembly shall not exceed 4.00".
A heavy-duty magnetic switch shall be used for control of open compartment door warning lights.
PULL STRAP, DOORS Bidder Complies: Yes ( ) No ( )
The eight (8) compartment doors, located all side compartments and speedlays, shall be provided with
pull straps.