Specifications

49 of 104
The information center indicates system voltage.
The information center, where applicable, includes a "Load Manager" screen indicating the following:
Load managed items list, with priority levels and item condition.
Individual load managed item condition:
ON = not shed
SHED = shed
SEQUENCER Bidder Complies: Yes ( ) No ( )
A sequencer shall be provided that automatically activates and deactivates vehicle loads in a preset
sequence thereby protecting the alternator from power surges. This sequencer operation shall allow a
gradual increase or decrease in alternator output, rather than loading or dumping the entire 12 volt
load to prolong the life of the alternator.
For improved reliability and ease of use, the load sequencing system shall be an integral part of the
vehicle's solid state control system requiring no additional components to perform load sequencing
tasks. Load sequencing systems which require additional components shall not be allowed.
Emergency light sequencing shall operate in conjunction with the emergency master light
switch. When the emergency master switch is activated, the emergency lights shall be activated one
by one at half-second intervals. Sequenced emergency light switch indicators shall flash while waiting
for activation.
When the emergency master switch is deactivated, the sequencer shall deactivate the warning light
loads in the reverse order.
Sequencing of the following items shall also occur, in conjunction with the ignition switch, at half-
second intervals:
Cab Heater and Air Conditioning
Crew Cab Heater (if applicable)
Crew Cab Air Conditioning (if applicable)
Exhaust Fans (if applicable)
Third Evaporator (if applicable)
EXTERIOR LIGHTING Bidder Complies: Yes ( ) No ( )
Exterior lighting shall comply with Federal Department of Transportation, Federal Motor Vehicle Safety
Standards and National Fire Protection Association requirements in effect at time of proposal.
Front headlights shall be Brightheadlight kit number Bi-XP4656-Kit, rectangular lights mounted in the
front trim housing. Headlights shall consist of two (2) lights mounted in the front trim on each side of
the cab grill. The outside light on each side shall contain a HID low and halogen high beam. The
inside light on each side shall contain a high beam light only.
The following LED lighting package shall provide long life lights for a lower cost of ownership:
One (1) Whelen 600 series LED combination directional/marker light shall be located in the
outside corners of the headlamp trim housing on each side.
Three (3) LED identification lamps shall be installed in the center of the cab on the trim above
the windshield.
Four (4) LED clearance lamp shall be installed, one (1) each side, facing forward and one (1)
each side, facing the side on the trim above the windshield.