Specifications

41 of 104
Hinged/flex microphone boom rotates 280 degrees for left or right dress
Volume control
One ear cup slotted (No NRR)
Each David Clark, Model U9910-BSW, belt station shall feature:
Marine grade, water-tight, impact resistant enclosure with rubberized skin
Hands free, full duplex, voice activation
Voice prompts to ensure wireless link status
Water-tight battery compartment
UNDER THE HELMET HEADSET Bidder Complies: Yes ( ) No ( )
There shall be five (5) under the helmet headset(s) provided officer and four in crewcab.
Each David Clark, Model H3342, headset shall feature:
5' Coiled cord
M1/DC microphone
Chrome microphone boom rotates 200 degrees for left or right dress
Microphone on/off button
Foam ear-seals
HEADSET HANGERS Bidder Complies: Yes ( ) No ( )
There shall be six (6) headset hanger(s) installed four in crew, driver and officer. The hanger(s) shall
meet NFPA 1901, Section 14.1.11 requirement for equipment mounting.
TWO WAY RADIO INSTALLATION Bidder Complies: Yes ( ) No ( )
There shall be one (1) customer supplied two way radio(s) sent to the apparatus manufacturers
preferred radio installer to be installed match job #25608. No antenna mount or whip shall be
included in this option. Specific radio shipping requirements shall be followed.
RADIO ANTENNA MOUNT Bidder Complies: Yes ( ) No ( )
There shall be three (3) standard 1.125", 18 thread antenna-mounting base(s) installed install on the
cab roof, spaced 36" apart on the cab roof with high efficiency, low loss, coaxial cable(s) routed to
the radio box. A weatherproof cap shall be installed on the mount.
VIDEO SYSTEM, SAFETY VISION WITH DISPLAY Bidder Complies: Yes ( ) No ( )
A Safety Vision video system with Model 620 color rear view and 622 color side view video cameras
shall be provided. All cameras feature a built in microphone, activated with the camera.
Cameras shall be on the driver side of the cab activated with the left turn signal and passenger side of
the cab activated with the right turn signal and at the rear of the vehicle, as close to center as possible,
activated when the vehicle is put into reverse.
Images shall be displayed in the cab on the vehicle display provided. Audio from the active camera
shall be via an amplified speaker with volume control located behind the driver seat.
VEHICLE CAMERA GUARD Bidder Complies: Yes ( ) No ( )
There shall be one (1) aluminum treadplate guard(s) fastened over the vehicle camera(s) located just
above the rear camera.
ELECTRICAL POWER CONTROL SYSTEM Bidder Complies: Yes ( ) No ( )
The primary power distribution shall be located forward of the officer's seating position and be easily
accessible while standing on the ground for simplified maintenance and troubleshooting. Additional
electrical distribution centers shall be provided throughout the vehicle to house the vehicle's electrical
power, circuit protection, and control components. The electrical distribution centers shall be located