Specifications

32 of 104
- High beam
ALARMS Bidder Complies: Yes ( ) No ( )
Audible steady tone warning alarm: A steady audible tone alarm shall be provided whenever a warning
message is present.
Audible pulsing tone caution alarm: A pulsing audible tone alarm (chime/chirp) shall be provided
whenever a caution message is present without a warning message being present.
Alarm silence: Any active audible alarm shall be able to be silenced by holding the ignition switch at
the top position for three (3) to five (5) seconds. For improved safety, silenced audible alarms shall
intermittently chirp every 30 seconds until the alarm condition no longer exists. The intermittent chirp
shall act as a reminder to the operator that a caution or warning condition still exists. Any new
warning or caution condition shall enable the steady or pulsing tones respectively.
INDICATOR LAMP AND ALARM PROVE-OUT Bidder Complies: Yes ( ) No ( )
Telltale indicators and alarms shall perform prove-out at initial power-up to ensure proper performance.
CONTROL SWITCHES Bidder Complies: Yes ( ) No ( )
For ease of use, the following controls shall be provided immediately adjacent to the cab instrument
panel within easy reach of the driver.
Emergency master switch: A molded plastic push button switch with integral indicator lamp shall be
provided. Pressing the switch shall activate emergency response lights and siren control. A green
lamp on the switch provides indication that the emergency master mode is active. Pressing the switch
again disables the emergency master mode.
Headlight / Parking light switch: A three (3)-position maintained rocker switch shall be provided. The
first switch position shall deactivate all parking lights and the headlights. The second switch position
shall activate the parking lights. The third switch position shall activate the headlights.
Panel backlighting intensity control switch: A three (3)-position momentary rocker switch shall be
provided. The first switch position decreases the panel backlighting intensity to a minimum level as the
switch is held. The second switch position is the default position that does not affect the backlighting
intensity. The third switch position increases the panel backlighting intensity to a maximum level as
the switch is held.
The following standard controls shall be integral to the gauge assembly and are located below the right
hand gauges. All switches have backlit labels for low light applications.
High idle engagement switch: A two (2)-position momentary rocker switch with integral indicator lamp
shall be provided. The first switch position is the default switch position. The second switch position
shall activate and deactivate the high idle function when pressed and released. The "Ok To Engage
High Idle" indicator lamp must be active for the high idle function to engage. A green indicator lamp
integral to the high idle engagement switch shall indicate when the high idle function is engaged.
"Ok to Engage High Idle" indicator lamp: A green indicator light shall be provided next to the high idle
activation switch to indicate that the interlocks have been met to allow high idle engagement.
The following standard controls shall be provided adjacent to the cab gauge assembly within easy
reach of the driver. All switches shall have backlit labels for low light applications.
Ignition switch: A three (3)-position maintained/momentary rocker switch shall be provided. The first
switch position shall deactivate vehicle ignition. The second switch position shall activate vehicle
ignition. The third momentary position shall disable the Command Zone audible alarm if held for three
(3) to five (5) seconds. A green indicator lamp shall be activated with vehicle ignition.