Specifications

25 of 104
SIDE ROLL PROTECTION Bidder Complies: Yes ( ) No ( )
The SRS system shall provide protection during a fast or slow 90-degree roll to the side, in which the
vehicle comes to rest on its side. The system shall analyze the vehicle's angle and rate of roll to
determine the optimal activation of the advanced occupant restraints.
The SRS system shall deploy the following components in the event of a side roll:
Air curtains mounted in the outboard bolster of outboard seat backs.
Suspension seats shall be retracted to the lowest travel position.
Seat belts shall be pre-tensioned to firmly hold the occupant in place.
SEATING CAPACITY Bidder Complies: Yes ( ) No ( )
The seating capacity in the cab shall be six (6).
DRIVER SEAT Bidder Complies: Yes ( ) No ( )
A seat shall be provided in the cab for the driver. The seat design shall be a cam action type with air
suspension. For increased convenience, the seat shall include electric controls to adjust the rake (15
degrees), height (1.12" travel) and horizontal (7.75" travel) position. Electric controls shall be located
below the forward part of the seat cushion. To provide flexibility for multiple driver configurations, the
seat shall have a reclining back, adjustable from 20 degrees back to 45 degrees forward. Providing for
maximum comfort, the seat back shall be a high back style with manual lumbar adjustment lever, for
lower back support, and shall include minimum 7.50" deep side bolster pads for maximum
support. The lumbar adjustment lever shall be easily located at the lower outboard position of the seat
cushion. For optimal comfort, the seat shall be provided with 17.00" deep dual density foam cushions
designed with EVC (elastomeric vibration control).
The seat shall include the following features incorporated into the side roll protection system.
Side air curtain shall be mounted integral to the outboard bolster of the seat back. The air curtain
shall be covered by a decorative panel when in the stowed position.
A suspension seat safety system shall be included. When activated in the event of a side roll, this
system shall pretension the seat belt, then retract the seat to its lowest travel position.
The seat shall be furnished with a three (3)-point, shoulder type seat belt. To provide quick, easy use
for occupants wearing bunker gear, the seat belt shall have a minimum 120.00" shoulder length and
55.00" lap length. The seat belt tongue shall be stored at waist position for quick application by the
seat occupant. The seat belt receptacle shall be provided on a cable conveniently nested next to the
seat cushion, providing easy accessibility. The seat belt shall be furnished with dual automatic
retractors that shall provide ease of operation in the normal seating position.
OFFICER SEAT Bidder Complies: Yes ( ) No ( )
A seat shall be provided in the cab for the passenger. The seat shall be a cam action type with air
suspension. For increased convenience, the seat shall include a manual control to adjust the horizontal
position (6.00" travel). The manual horizontal control shall be a towel-bar style located below the
forward part of the seat cushion. For optimal comfort, the seat shall be provided with 17.00" deep
dual density foam cushions designed with EVC (elastomeric vibration control). To ensure safe
operation, the seat shall be equipped with seat belt sensors in the seat cushion and belt receptacle that
shall activate an alarm indicating a seat is occupied but not belted.
The seat back shall be an SCBA back style with 7.50 degree fixed recline angle, and shall include
minimum 4.50" wide x 7.50" deep side bolster pads for maximum support. The SCBA cavity shall be
adjustable from front to rear in 1.00" increments, to accommodate different sized SCBA
cylinders. Moving the SCBA cavity shall be accomplished by unbolting, relocating, and re-bolting it in
the desired location.
The seat shall include the following features incorporated into the side roll protection system.