Specifications

19 of 104
CAB LIFT Bidder Complies: Yes ( ) No ( )
A hydraulic cab lift system shall be provided, consisting of an electric-powered hydraulic pump, fluid
reservoir, dual lift cylinders, remote cab lift controls and all necessary hoses and valves.
The cab lift controls shall be located at the driver side front of the cab, easily accessible under the full
width front access hood. The controls shall include a permanently mounted raise/lower switch. For
enhanced visibility during cab tilt operations, a remote control tether with on/off switch shall be
supplied on a coiled cord that shall extend from 2.00' (coiled) to 6.00' (extended).
The rear of the cab shall be locked down by a two (2)-point, automatic, hydraulic, double hook
mechanism that fully engages after the cab has been lowered (self-locking). The dual 2.25" diameter
hydraulic cylinders shall be equipped with a velocity fuse that protects the cab from accidentally
descending when the cab is in the tilt position.
For increased safety, a redundant mechanical stay arm shall be provided that must be manually put in
place on the driver side between the chassis and cab frame when cab is in the raised position. This
device shall be manually stowed to its original position before the cab can be lowered.
INTERLOCK, CAB LIFT TO PARKING BRAKE Bidder Complies: Yes ( ) No ( )
The cab lift safety system shall be interlocked to the parking brake. The cab tilt mechanism shall be
active only when the parking brake is set and the ignition switch is in the on position. If the parking
brake is released, the cab tilt mechanism shall be disabled.
GRILLE Bidder Complies: Yes ( ) No ( )
A bright finished aluminum mesh grille screen, inserted behind a formed bright finished grille surround,
shall be provided on the front center of the cab, and shall serve as an air intake to the radiator.
DOOR JAMB SCUFFPLATES Bidder Complies: Yes ( ) No ( )
All cab door jambs shall be furnished with a brushed stainless steel scuffplate, mounted on the striker
side of the jamb.
SCUFFPLATES, REAR CAB CORNER GUARDS Bidder Complies: Yes ( ) No ( )
Both rear cab corners shall be furnished with a full height brushed stainless steel corner guard
scuffplate. The guard shall extend 1.00" from the corner to protect paint from damage when pulling
items (such as booster hose) around the cab.
TRIM BAND (cab face) Bidder Complies: Yes ( ) No ( )
A 10.00" band of 22 gauge polished stainless steel trim shall be installed across the front of the cab,
from door hinge to door hinge. Polished stainless steel corner covers shall be provided at the cab turn
signals. The trim band shall be centered on the head lights and applied with two-sided tape. A .625"
self adhesive trim strip shall be applied around the perimeter of the trim band.
MIRRORS Bidder Complies: Yes ( ) No ( )
One (1) Ramco, Model 6000-PCHR, polished aluminum mirror shall be mounted on each of the cab
doors. The mirrors shall be 9.25" x 13.50", with a convex section. The mirror head shall have a highly
polished aluminum finish.
The flat glass in each mirror shall be heated and adjustable, with remote controls that are convenient
to the driver.
The convex section in each mirror shall be heated and adjustable, with remote controls that are
convenient to the driver.
SIDE VIEW MIRROR Bidder Complies: Yes ( ) No ( )
An 8.00" diameter convex mirror shall be provided over the officer's side front corner of the cab. The
mirror shall provide the driver with a view of the passenger side of the vehicle.