Specifications

14 of 104
FUEL TANK Bidder Complies: Yes ( ) No ( )
A 65-gallon fuel tank shall be provided and mounted at the rear of the chassis. The tank shall be
constructed of 12-gauge, hot rolled steel. It shall be equipped with swash partitions and a vent. To
eliminate the effects of corrosion, the fuel tank shall be mounted with stainless steel straps. (no
exception).
A .75" drain plug shall be provided in a low point of the tank for drainage.
A fill inlet shall be located on the left hand side of the body and be covered with a hinged, spring
loaded, stainless steel door that is marked "Ultra Low Sulfur - Diesel Fuel Only."
A .50" diameter vent shall be provided running from top of tank to just below fuel fill inlet.
The tank shall meet all FHWA 393.67 requirements including a fill capacity of 95 percent of tank
volume.
All fuel lines shall be provided as recommended by the engine manufacturer.
DIESEL EXHAUST FLUID TANK Bidder Complies: Yes ( ) No ( )
A 4.5 gallon diesel exhaust fluid (DEF) tank shall be provided and mounted in the driver's side
body forward of the rear axle. The tank shall be constructed of 16-gauge type 304- L stainless steel.
A .50" drain plug shall be provided in a low point of the tank for drainage.
A fill inlet shall be located on the driver's side of the body and be covered with a hinged, spring loaded,
stainless steel door that is marked "Diesel Exhaust Fluid Only".
The tank shall meet the engine manufacturer’s requirement for 10 percent expansion space in the
event of tank freezing.
The tank shall include an integrated heater unit that utilizes engine coolant to thaw the DEF in the
event of freezing.
FUEL SHUTOFF Bidder Complies: Yes ( ) No ( )
A fuel line shutoff valve shall be installed on both the inlet and outlet of the primary fuel filter.
TRANSMISSION Bidder Complies: Yes ( ) No ( )
An Allison Gen IV, model EVS 3000P, electronic torque converting automatic transmission shall be
provided.
The transmission shall be equipped with prognostics to monitor oil life, filter life, and transmission
health. A wrench icon on the shift selector's digital display shall indicate when service is due.
Two (2) PTO openings shall be located on left side and top of converter housing (positions 9 o'clock
and 3 o'clock).
A transmission temperature gauge with red light and audible alarm shall be installed on the cab dash.
TRANSMISSION SHIFTER Bidder Complies: Yes ( ) No ( )
A six (6)-speed push button shift module with the five (5) + one (1) "Mode" button shall be mounted
to right of driver on console. Shift position indicator shall be indirectly lit for after dark operation.
The Allison shifter shall be a double-digit display model.
The transmission ratio shall be: 1st - 3.51 to 1.00, 2nd - 1.91 to 1.00, 3rd - 1.43 to 1.00, 4th - 1.00 to
1.00, 5th - 0.75 to 1.00, 6th - 0.64 to 1.00, R - 4.80 to 1.00.
TRANSMISSION PROGRAMMING Bidder Complies: Yes ( ) No ( )
The transmission shall be programmed to automatically shift the transmission to neutral when the
parking brake is set to simplify operation and increase operational safety. (no exception).