Specifications

93 of 104
CIRCUIT BREAKER PANEL Bidder Complies: Yes ( ) No ( )
The circuit breaker panel shall be located in the front wall of the driver’s side forward brass
compartment.
COMMAND LIGHT Bidder Complies: Yes ( ) No ( )
There shall be one (1) Command Light, Model CL602 light tower with six (6) Whelen Pioneer, Model
PFP2AC powered LED flood lights provided on the apparatus top of the crewcab roof.
The handheld controller shall be installed locate the controls inside the front driver's side compartment,
high on the front bulkhead to the rear of the pump panel.
ELECTRIC CORD REEL Bidder Complies: Yes ( ) No ( )
Furnished with the 120 volt AC electrical system shall be a Hannay, series 1600, cord reel. The reel
shall be provided with a 12-volt electric rewind switch, that is guarded to prevent accidental operation
and labeled for its intended use. The switch shall be protected with a fuse and installed at a height not
to exceed 72 inches above the operators standing position.
The exterior finish of the reel(s) shall be painted job color matching the body exterior.
A Nylatron guide shall be provided to aid in the payout and loading of the reel. A ball stop shall be
provided to prevent the cord from being wound on the reel.
A label shall be provided in a readily visible location adjacent to the reel. The label shall indicate
current rating, current type, phase, voltage and total cable length.
A total of one (1) cord reel shall be provided in hatch compartment with access from front passenger's
side compartment.
The cord reel should be configured with three (3) conductors.
CORD Bidder Complies: Yes ( ) No ( )
Provided for electric distribution shall be one (1) length installed on the reel of 200 feet of yellow 10/3
electrical cord, weather resistant 105 degree C to -50 degree C, 600 volt jacketed SOOW cord. No
connector shall be installed on the end of the cord.
PORTABLE JUNCTION BOX Bidder Complies: Yes ( ) No ( )
There shall be four (4) 120 vac 15 amp twist lock NEMA L5-15 receptacles provided in a portable
junction box. The junction box shall be of weatherproof construction and have flip up lids lined with
soft neoprene rubber at each outlet opening. Each side of the junction box shall be fitted with a .25
inch thick, polypropylene faceplate which is brightly backlit with a 25 watt lamp.
No connector.
A total of one (1) shall be provided.
ROLLER GUIDE Bidder Complies: Yes ( ) No ( )
Installed on the compartment wall, adjacent to the reel, shall be a three (3) sided roller assembly to
aid in the payout of the cord/hose from the reel. The top is open to drop in the cord/hose. The guide
shall have a positive locking hinge to fold the guide against the wall in the stored position. There shall
be one (1) for each reel for a total of five (5) roller guides.
JUNCTION BOX HOLDER Bidder Complies: Yes ( ) No ( )
There shall be a stainless steel junction box holder installed adjacent to the cord reel. A total of one
(1) shall be installed.
Location shall be LOCATE AT PICK-UP.