Specifications

DM562AP
Operation Manual & AT Command Set
Integrated Data/Fax/Voice/Speakerphone Modem
Preliminary
13
Version: DM562AP-MA-P01
February 2, 2004
\Jn DTE Baud Rate Adjustment Selection.
\J0* Disables DTE rate adjustment. DTE rate is
constant regardless of data link speed.
\J1 Enables DTE rate adjustment. DTE matches
data link speed
\Kn Break Control Selection.
\K0 Enters the Command Mode, but does not send
a Break to remote modem. (To send a Break
after use the \B command).
\K1 Empty data buffers and immediately sends a
Break to remote.
\K2 Same as AT\K0.
\K3 Immediately send a Break.
\K4 Same as AT\K0.
\K5* Send a Break in sequence with any data
received from host.
\Nn Data Link Selection.
\N0 Selects Normal data link.
\N1 Selects Direct data link.
\N2 Selects MNP Reliable link only.
\N3 Selects MNP Auto-reliable link.
\N4 Selects V.42 reliable link with phase detection.
\N5* Selects V.42 auto-reliable link with phase
detection.
\N6 Selects V.42 reliable link without phase
detection.
\N7 Selects V.42 auto-reliable link without phase
detection.
\Qn Flow Control Selection.
\Q0 Disables flow control.
\Q1 Selects XON\XOFF in-band flow control.
\Q2 Selects CTS hardware flow control.
\Q3* Selects RTS\CTS hardware flow control.
\Tn Set Inactive Timer.
Set inactivity timer to n minutes (n = 0 to 90).
Default = 0.
\Vn V42/MNP Extended Response Selection.
\V0 Disables V42/MNP extended responses.
\V1* Enables V42/MNP extended responses.
\Xn XON\XOFF Pass-through Selection.
\X0* Process XON\XOFF and don't pass through.
\X1 Processes XON\XOFF and pass through.