User Manual

16
* These menus are related to other settings. They are not visible unless related settings are enabled.
Sub Menu Units Range Defaults
PIPE FILL
Pipe Fill Mode selection On, Off Off
* Jump Ramp Time seconds Off, 1 - 999 Off
* Jump Final Speed % 0-100% 50
* Pipe Fill Time seconds 5 - 999 100
* Pipe Empty Pressure Unitless 0 - 9999 200
* Pipe Empty Time seconds 0 - 999 200
Sub Menu Units Range Defaults
INPUTS
Program Input 1 selection VSD Fault
Program Input 2 selection No Flow
Program Input 3 selection Pump 1 Manual Run
Program Input 4 selection Pump 1 Stop
Program Input 5 selection Not selected
Program Input 6 selection Not selected
Program Input 7 selection Reset
Program Input 8 selection Soft Pause
Any of the
following can be
selected on any
input and used
multiple times
Not selected,
Set Point 2 - 8,
Soft Pause,
Soft Pause JP
Run,
Emergency Stop,
Pump 1 - 6
Protection,
Pump 1 - 6 Stop,
Pump 1 - 6
Manual Run,
Fire Mode, Cycle
Pumps,
Shutdown Verify,
VSD Fault, Reset,
No Flow,
Aux Input 1 - 3,
Pump 1 - 6 No
Flow Protection,
Flow Pulse,
Low Level Pause
Analogue Input 1 selection
Disabled, Control
Pressure, Flow,
Set Point Input
Pressure
Analogue Input 2 selection
None, Control
Pressure, Flow,
Set Point Input,
Backup Pressure
None